Development VeeaHubs in VHC 1.2¶

The first step is to tell vhc about the VeeaHubs you plan to interact with. This is done using the set of commands under vhc hub config.

CODE

$ vhc hub config --help
Add, remove, and configure VeeaHub information.
All hub configuration is stored in ~/.vhc/config.yaml.

Usage:
  vhc hub config [flags]
  vhc hub config [command]

Available Commands:
  add-hub        Adds a hub to the configuration.
  remove-hub     Removes a hub from the configuration.
  set-active-hub Sets the hub to be used for all subsequent operations.
  show           Shows hub information.
  update-hub     Updates the IPv4 address for a configured hub.

Flags:
  -h, --help   help for config

Use "vhc hub config [command] --help" for more information about a command.

To add a new VeeaHub, run the command

vhc hub config add-hub --ip-addr <your-hub-ip> --serial-number <your-hub-serial> <your-hub-name>

but substitute the appropriate IP address, Serial Number, and a Nickname for each VeeaHub.

For example:

vhc hub config add-hub --ip-addr 192.168.10.176 --serial-number C25CTW00000000001567 vhc25

When you’re done, you can use the vhc hub config show command to show the configured VeeaHubs

CODE

$ vhc hub config show
hub:
  active: vhc25
  hubs:
  - id: vhc05
    ipv4Addr: 10.20.1.141
    serialnumber: C05BCB00C0A000000886
  - id: vhe09
    ipv4Addr: 10.20.4.50
    serialnumber: E09BCWA0C0B000000627
  - id: vhe10
    ipv4Addr: 10.20.0.49
    serialnumber: E10CUW0C80C000000001
  - id: vhc25
    ipv4Addr: 192.168.10.176
    serialnumber: C25CTW00000000001567

Entries can be modified using vhc hub config update-hub or removed using vhc hub config remove-hub.

You can also set a default hub with the vhc hub config set-default-hub <hub-name> command. For example:

CODE

vhc hub config set-default-hub vhc25

As with most other commands, hitting the tab key after the command will provide you with a list of configured hubs to choose.